problem with speedball upgrade installation

Timbehh · 2518

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Timbehh

  • Jr. Member
  • **
    • Posts: 20
on: March 17, 2012, 10:00:47 AM
Heya folks. At last i got around of installing the speedball on my crack. Everything went fine (or so i thought), but one of the leds on big board isn
« Last Edit: March 17, 2012, 10:08:11 AM by Timbehh »


Offline Grainger49

  • Hero Member
  • *****
    • Posts: 7175
Reply #1 on: March 17, 2012, 10:12:56 AM
Check that the silver end is where it should be.  We will assume that the LED that isn't glowing is on the right channel.  If all the LEDs do not glow you will get low volume in one or both channels.

If the LED doesn't need to have the ends swapped post voltage.  But only those that are greater than 15% off from expected.


Offline Timbehh

  • Jr. Member
  • **
    • Posts: 20
Reply #2 on: March 17, 2012, 10:35:05 AM
Led is positioned correctly, silver lining is facing the right way. I will post voltages tomorrow, it


Offline Doc B.

  • Administrator
  • Hero Member
  • *****
    • Posts: 9657
    • Bottlehead
Reply #3 on: March 17, 2012, 05:15:54 PM
Make sure that the 2N2222A and 2N2907A transistors are in the right places

Dan "Doc B." Schmalle
President For Life
Bottlehead Corp.

Offline Noskipallwd

  • Sr. Member
  • ****
    • Posts: 353
Reply #4 on: March 17, 2012, 08:17:06 PM
Quote from: Doc B. on March 17, 2012, 05:15:54 PM
Make sure that the 2N2222A and 2N2907A transistors are in the right places
Yep, what Doc said, I switched those transistors myself and the symptoms were pretty much identical.

Cheers,
Shawn

Shawn Prigmore

Pages: 1   Go Up
« previous next »