stereomourII shunt regulator assembly question

Jay · 2521

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Jay

  • Full Member
  • ***
    • Posts: 142
on: December 10, 2016, 11:56:09 AM
I'm getting a little confused.  In the StereomourII shunt regulator manual on page 19, it says "Attach and solder the red wire connected to IA on the
Shunt Regulator board to 27U."  On page 20, it says "Attach and solder the red wire connected to IA on the Shunt Regulator board to 34U."  I assume the instruction on page 20 should have said to connect the red wire from IB to 34U.  Is that correct?

Many thanks,
Jay

Jay L.

Offline Sugar Man

  • Full Member
  • ***
    • Posts: 127
    • The Last Honest Lawyer
Reply #1 on: December 11, 2016, 05:26:39 AM
Yes, that is a typo.  Zooming in on the picture you can see IB and I just double-checked mine.

Mike "Stein" Ayotte

Current Gear:

Elekit TU-8600 300B w/Lundahl Trannies
Herron Audio VTPH-2a
Rega RP8 w/ Apheta 2
Bluesound Node 2i
Audio Note E Speaker Kit-04 w/ AlNiCo drivers

Stereomour II w/ Jupiters
Eros w/ Mundorf Silver Oils
Blumenstein Orcas & Subs

Offline Jay

  • Full Member
  • ***
    • Posts: 142
Reply #2 on: December 11, 2016, 06:40:03 AM
Thanks Mike

Jay L.

Pages: 1   Go Up
« previous next »