DC filament polarity quesstion.

Mucker · 6479

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Mucker

  • Sr. Member
  • ****
    • Posts: 392
on: January 22, 2024, 11:05:05 AM
I do a bit of researching of the forums here and came across a thread in the Kaiju forum about when using the DC filament to wire the tube sockets at different polarity and then swap the tubes annually. Does this apply to Stereomour and how important is this? There is no mention of it in the DC filament manual so I assumed it to not be critical. I know the Kaiju is 300B but it seems that 2A3 would be the same??? Thank you. 
« Last Edit: January 22, 2024, 12:21:43 PM by Mucker »


Offline Paul Joppa

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 5830
Reply #1 on: January 22, 2024, 01:22:20 PM
Yes, the same theory applies.

No, it's not "critical" in either amp, but the effect is about half as much in the 2A3 amp, since the filament voltage is half as great.

Paul Joppa

Offline Mucker

  • Sr. Member
  • ****
    • Posts: 392
Reply #2 on: January 22, 2024, 02:41:29 PM
Awesome. Thanks PJ!

EDIT: I just checked my wiring and both sockets were wired the same (randomly) so ended up switching the wire pair at the board on one side.
« Last Edit: January 22, 2024, 03:52:22 PM by Mucker »


Pages: 1   Go Up
« previous next »