Smash Output Wiring.

Chris65 · 3739

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Chris65

  • Sr. Member
  • ****
    • Posts: 341
on: September 09, 2014, 11:57:31 AM
Hi, just a quick tech question - I noticed in the neat build thread by Stedes, that the 2 outputs are tied together on each side by resistors.
Just wondered the reason for that? Does that not attenuate the signal into the 2nd outputs (unless a very low value resistor).

Thanks,
Chris


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19750
Reply #1 on: September 09, 2014, 12:13:47 PM
The resistor value is very, very low.  This was a suggestion from PJ, but I can't quite remember why...

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Chris65

  • Sr. Member
  • ****
    • Posts: 341
Reply #2 on: September 09, 2014, 12:24:13 PM
Thanks PB, I guess there's some reason.... ;)


Offline Stedes

  • Jr. Member
  • **
    • Posts: 32
Reply #3 on: September 09, 2014, 05:32:29 PM
Hi all...would be interesting to know why. However to me (audibly) there is no difference between the two sets of outputs.


Pages: 1   Go Up
« previous next »