News: Not receiving your account activation email? Contact [email protected]
November 26, 2020, 10:00:20 PM

Author Topic: Smash Output Wiring.  (Read 1108 times)

0 Members and 1 Guest are viewing this topic.

Offline Chris65

  • Sr. Member
  • ****
  • Posts: 340
Smash Output Wiring.
« on: September 09, 2014, 11:57:31 AM »
Hi, just a quick tech question - I noticed in the neat build thread by Stedes, that the 2 outputs are tied together on each side by resistors.
Just wondered the reason for that? Does that not attenuate the signal into the 2nd outputs (unless a very low value resistor).

Thanks,
Chris

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 13884
Re: Smash Output Wiring.
« Reply #1 on: September 09, 2014, 12:13:47 PM »
The resistor value is very, very low.  This was a suggestion from PJ, but I can't quite remember why...
Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Chris65

  • Sr. Member
  • ****
  • Posts: 340
Re: Smash Output Wiring.
« Reply #2 on: September 09, 2014, 12:24:13 PM »
Thanks PB, I guess there's some reason.... ;)

Offline Stedes

  • Jr. Member
  • **
  • Posts: 32
Re: Smash Output Wiring.
« Reply #3 on: September 09, 2014, 05:32:29 PM »
Hi all...would be interesting to know why. However to me (audibly) there is no difference between the two sets of outputs.