Resistance check for #32

[[email protected]]

Finished assembly last night, now on to resistance checks. Everything is OK except for #32. Manual shows a * but it reads 0 ohms. Both 29 and 32 are part of the ground bus (page 35) so i would expect it to read 0 ohms. All other resistance checks (including change in #45) check OK.

[Paul Birkeland]

Yup, looks like a typo.

-PB

[[email protected]]

Thanks, from looking at the ckt and comparing the symmetric layout it seems it had to be 0 ohms, but since this is a new kit I just wanted to be doubly sure before applying power. Hard to put the smoke back in.