Speedball upgrade - small board: One LED not lighting, one V reading out of spec

Luxifer · 3170

« previous next »
Pages: 1 2 3   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Luxifer

  • Jr. Member
  • **
    • Posts: 23
Reply #30 on: December 15, 2018, 10:07:03 AM
I am pretty sure I cut the leads to the resistors too close to the resistor body to re-use them. Unless there is some technique to re-attach wires that doesn't leave them brittle? I tried to solder them, but I was soldering between two flat faces, and the result was very brittle.

Are there any important specifications to the resistor, besides it being 22.1 kOhms? I can likely find one in the city I'm in, and test using that.


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19771
Reply #31 on: December 15, 2018, 11:16:47 AM
20K-24K is going to work fine.  I'd look for a resistor that's around 1/2-1W.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Luxifer

  • Jr. Member
  • **
    • Posts: 23
Reply #32 on: December 17, 2018, 04:05:35 PM
Tested with some 22 kOhm resistors, and all was good, so I went ahead with the replacement part build, installed the rest of the Speedball, and everything is working perfectly.

Thanks so much for your help!


Pages: 1 2 3   Go Up
« previous next »