smash up board builds

tipatina · 1818

0 Members and 1 Guest are viewing this topic.

Offline tipatina

  • Jr. Member
  • **
    • Posts: 22
on: August 25, 2018, 07:20:47 AM
Boards are built, guess there is no way of testing them before they go in?



Offline bernieclub

  • Full Member
  • ***
    • Posts: 114
Reply #1 on: August 25, 2018, 07:26:19 AM
Lower board, near center, northwest quadrant...three holes missing solder!

Bernie Zitomer


Offline tipatina

  • Jr. Member
  • **
    • Posts: 22
Reply #2 on: August 25, 2018, 08:00:38 AM
Looks like Q1 B side. Fixed it. Thanks!



4krow

  • Guest
Reply #3 on: September 05, 2018, 05:13:23 PM
Good catch. I had to look twice. Same sort of thing happens to me, unless I solder each piece one at a time. Just a quick: I have been using nail clippers to trim leads for years now because they can trim right up to the solder joint. Try it out. So much better than many flush cut trimmers.