News: Not receiving your account activation email? Contact [email protected]
December 03, 2020, 05:50:19 PM

Author Topic: Continuity Question  (Read 215 times)

0 Members and 4 Guests are viewing this topic.

Offline Jimb0

  • Sr. Member
  • ****
  • Posts: 254
Continuity Question
« on: March 30, 2020, 03:09:11 PM »
Tested the continuity but I'm getting 0.001 for all three pins
I set my voltometer to AC/2v like in the picture

Is this okay?

Offline Doc B.

  • Administrator
  • Hero Member
  • *****
  • Posts: 8304
    • Bottlehead
Re: Continuity Question
« Reply #1 on: March 30, 2020, 04:14:49 PM »
That's the wrong end of the knob you're looking at. It's pointing to the continuity setting in the ohms scales at about 7:30 rather than the 2VAC scale at 1:30. If you don't have a continuity beeper on your meter you can just use your lowest ohms scale.
Dan "Doc B." Schmalle
President For Life
Bottlehead Corp.

Offline Jimb0

  • Sr. Member
  • ****
  • Posts: 254
Re: Continuity Question
« Reply #2 on: March 31, 2020, 08:44:26 AM »
perfect thanks Doc! I got 0.3 ohms for each reading

Offline Doc B.

  • Administrator
  • Hero Member
  • *****
  • Posts: 8304
    • Bottlehead
Re: Continuity Question
« Reply #3 on: March 31, 2020, 09:40:33 AM »
Sounds like you're good to go.
Dan "Doc B." Schmalle
President For Life
Bottlehead Corp.