Power switch wire

oguinn · 1454

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline oguinn

  • Global Moderator
  • Sr. Member
  • *****
    • Posts: 896
on: May 29, 2020, 06:09:46 AM
I read too fast and trimmed the twisted shielded pair’s red wire to 2”. Can I twist and solder a jumper to that 2” piece and cover it in heat shrink, or does that run a risk since it’s going to the power transformer?

Hopefully this is my dumb mistake for this build.

Jameson O'Guinn

-

Main System: Schiit Bifrost MB, Rega Planar 6 with Exact cartridge, Eros 2, BeePre, Kaiju/Stereomour II, Jagers, Mainline

Desktop System: Crack with Speedball

Offline oguinn

  • Global Moderator
  • Sr. Member
  • *****
    • Posts: 896
Reply #1 on: May 29, 2020, 06:16:09 AM
Actually, nevermind. I’m going to order a new length of shielded twisted wire. Not worth it.

Jameson O'Guinn

-

Main System: Schiit Bifrost MB, Rega Planar 6 with Exact cartridge, Eros 2, BeePre, Kaiju/Stereomour II, Jagers, Mainline

Desktop System: Crack with Speedball

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19750
Reply #2 on: May 29, 2020, 06:22:10 AM
Yeah, on a Mainline I would definitely advise that patience is the most valuable asset. 

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline oguinn

  • Global Moderator
  • Sr. Member
  • *****
    • Posts: 896
Reply #3 on: May 29, 2020, 06:27:20 AM
Yep, should have re-read that. Measure twice cut once.

I actually think there’s enough shielded twisted cable in here to continue on.

Jameson O'Guinn

-

Main System: Schiit Bifrost MB, Rega Planar 6 with Exact cartridge, Eros 2, BeePre, Kaiju/Stereomour II, Jagers, Mainline

Desktop System: Crack with Speedball

Pages: 1   Go Up
« previous next »