All resistance test's correct except for 45

jamesondrums · 3729

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline jamesondrums

  • Jr. Member
  • **
    • Posts: 25
on: June 04, 2020, 10:28:15 AM
All of my resistance numbers are correct except for 45. I am getting a fluctuating number (i'm guessing because something is being charged by the multimeter?) anywhere from 3.00 - 6.00, depending on how long I have been using the meter. Any ideas?


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19714
Reply #1 on: June 04, 2020, 10:31:39 AM
A fluctuating number there is good.  There was a manual revision that happened with the Reduction some time ago that didn't get picked up by the automated manual distribution software, and there were some resistance values that got adjusted in that revision, so if your manual says that 45 should be 0 ohms, that's an error.

-PB

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Pages: 1   Go Up
« previous next »