voltage discrepancy OA/OB

denti alligator · 1284

« previous next »
Pages: 1 2   Go Down

0 Members and 1 Guest are viewing this topic.

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19353
Reply #15 on: June 29, 2020, 06:22:13 AM
You should also swap both the input and output cables at the same time to rule out that you have a flaky cable.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline denti alligator

  • Hero Member
  • *****
    • Posts: 1149
Reply #16 on: June 29, 2020, 08:43:15 AM
OK, I went over every joint, including removing the PC boards to get under them and reflowing the underside of each board. Same readings and same off-center sound. Is it time to send it in?

- Sam

Rega P3-24 (w/AT 150MLX) w/Groovetracer upgrades / Eros II / FLAC >J.River >DSD256 >Gustard X20 / Moreplay > Stereomour II / Klipsch Forte II w/Crites upgrades / C4S S.E.X. 2.0 +Nickel MQ Iron / Speedball Crack / Sennheiser HD600 w/Cardas cable

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19353
Reply #17 on: June 29, 2020, 08:50:51 AM
Please be sure this isn't just a cable issue.  All of the Eros 2 kits that I have received for repair so far have been working perfectly.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline denti alligator

  • Hero Member
  • *****
    • Posts: 1149
Reply #18 on: June 29, 2020, 08:55:46 AM
I'll double check, but these are the same cables that were plugged into my Seduction, which worked fine.
I switched the input and output cables. Same problem. I'll try another set to be sure.

- Sam

Rega P3-24 (w/AT 150MLX) w/Groovetracer upgrades / Eros II / FLAC >J.River >DSD256 >Gustard X20 / Moreplay > Stereomour II / Klipsch Forte II w/Crites upgrades / C4S S.E.X. 2.0 +Nickel MQ Iron / Speedball Crack / Sennheiser HD600 w/Cardas cable

Pages: 1 2   Go Up
« previous next »