Should upgrades be done in any particular order?

Twodawgzz · 939

0 Members and 1 Guest are viewing this topic.

Offline Twodawgzz

  • Jr. Member
  • **
    • Posts: 26
on: August 05, 2020, 08:01:19 AM
I have the DC Filament Supply, Shunt Regulator, and MourQuiet Attenuator upgrades to install.

Does it matter which one I work on first?



Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19319
Reply #1 on: August 05, 2020, 08:16:15 AM
The absolute most important thing is that you build the amp stock first and getting it 100% working.  It's far harder to debug an amp with upgrades when you don't know whether it's the upgrades or the stock build that caused the issue.

I would put the DC filament in first, because it's far easier than the other two upgrades.  I would do the SR driver next, then the attenuator last, mostly because you'll be well warmed up by then and you want to do your best work on that attenuator.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man


Offline Twodawgzz

  • Jr. Member
  • **
    • Posts: 26
Reply #2 on: August 05, 2020, 11:42:52 AM
Thanks Paul.