News: Trouble logging in? Log in from the login page.
September 30, 2020, 06:07:39 PM

Author Topic: 0.1uf boards caps  (Read 168 times)

0 Members and 1 Guest are viewing this topic.

Offline Alby0521

  • Full Member
  • ***
  • Posts: 59
0.1uf boards caps
« on: August 14, 2020, 03:43:25 PM »
Hello

Is it worth to upgrade the 0.1uf caps on the 2 pc boards? Anyone had good experiences on this upgrade? If so what good brands can be used which don’t brake the bank?

I already got the 10uf, 100uf and 0.1uf(the one attached to the terminal strips) for a future upgrade but I see  that some people upgraded the 0.1uf caps on the boards too so I was interested in any experience.

Thanks in advance.

AB

Offline Alby0521

  • Full Member
  • ***
  • Posts: 59
Re: 0.1uf boards caps
« Reply #1 on: August 16, 2020, 10:24:46 AM »
Hello,

No one had success with the spoken upgrade?

Best

AB

Offline grufti

  • Sr. Member
  • ****
  • Posts: 315
Re: 0.1uf boards caps
« Reply #2 on: August 16, 2020, 10:42:15 AM »
The questions that you might want to ask yourself is: why is swapping one capacitor for another always an upgrade? What is the function of that capacitor in the circuit?

Offline Alby0521

  • Full Member
  • ***
  • Posts: 59
Re: 0.1uf boards caps
« Reply #3 on: August 17, 2020, 05:01:00 PM »
I’m not completely sure what that cap does that’s why I’m asking here as I saw some people changing caps in that position.

Thanks

AB

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 13595
Re: 0.1uf boards caps
« Reply #4 on: August 17, 2020, 06:40:45 PM »
I haven't heard huge differences in caps there.  I have had to do some repairs where huge 0.1uF caps have destroyed the PC board because they are too heavy.
Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Paul Joppa

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 5122
Re: 0.1uf boards caps
« Reply #5 on: August 17, 2020, 07:12:10 PM »
The 0.1uF cap on the shunt regulator, along with it's associated resistor, stabilizes the feedback loop to prevent oscillation and/or ringing. Don't change the values! It's been a long time since I did the analysis, but if I recall correctly the instability happens at around a megaherz, which would lead sometimes to very hard-to-trace, unpredictable effects.

If you do change the cap, use something physically smaller to minimize RF sensitivity. Don't use Mylar without re-doing the stability analysis because Mylar develops a significant ESR at radio frequencies. Maybe something like mica, or NPO (C0G) ceramic.
Paul Joppa

Offline Alby0521

  • Full Member
  • ***
  • Posts: 59
Re: 0.1uf boards caps
« Reply #6 on: August 17, 2020, 07:33:34 PM »
Hello Paul and Paul

Very clear thank a lot.
I’ll let the caps be on that position.

Best

AB