News:
September 25, 2023, 03:54:00 AM
« previous next »
Pages: [1]   Go Down

Author Topic: Stereomour almost working [resolved]  (Read 420 times)

0 Members and 1 Guest are viewing this topic.

Offline Wayne100

  • Newbie
  • *
  • Posts: 6
Stereomour almost working [resolved]
« on: March 20, 2022, 08:04:27 AM »
Did some troubleshooting with doc the other day and found 2 blown resistors going from terminal 44 to term 30 and 31. sent me new ones ,put them in and did voltage checks. All good except terminal 4 and 17 both zero on startup which is right but after about 30 seconds both read 9 volts. Is this ok?
« Last Edit: March 20, 2022, 08:37:48 AM by Paul Birkeland »
Logged

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 18655
Re: Stereomour almost working
« Reply #1 on: March 20, 2022, 08:06:48 AM »
Do they read 9V, or something else like 9mV?
Logged
Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Wayne100

  • Newbie
  • *
  • Posts: 6
Re: Stereomour almost working
« Reply #2 on: March 20, 2022, 08:14:32 AM »
you are right mv
Logged

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 18655
Re: Stereomour almost working
« Reply #3 on: March 20, 2022, 08:14:52 AM »
0.009V is plenty close to 0V in that position.
Logged
Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Wayne100

  • Newbie
  • *
  • Posts: 6
Re: Stereomour almost working
« Reply #4 on: March 20, 2022, 08:15:39 AM »
Thanks Paul
Logged
Pages: [1]   Go Up
« previous next »