Robin Hood 2A3

Paul Joppa · 3143

0 Members and 1 Guest are viewing this topic.

Offline Paul Joppa

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 5751
on: February 26, 2013, 05:01:11 PM
Hey all, just a short note to say I put up a DIY design on Mike's board, using a 2A3 with the Robin Hood output transformer. Not parafeed or anything, just the simplest design I could do at the lowest cost - since the RH transformers are Mike's contribution to low-cost SETs.

http://www.audioasylum.com/forums/magnequest/bbs.html

Discussion should be on Mike's board, since this is not a Bottlehead thing at all. I only mention it because a lot of Mike's fans hang out here as well.  :^)

Paul Joppa