A little help please [resolved]

[octavian]

I had the same readings as you as far as resistances went, so 45 is an error. I found one more error which I'll bring up when I get home tonight and can check out my resistances sheet. Somewhere in the 30s if I remember right. Something that's a star should be 0 as it's on the ground bus.

[Strikkflypilot]

VERY good looking build, Karl!

[Karl5150]

Thanks, looking fwd to getting the V #s good and giving a listen.
Man is Octavian's workspace clean and uncluttered, I'm betting the finished product reflects that attention.

[octavian]

Hah! I totally didn't push all of the junk to the other side of the table so it would be out of the shot!

[Karl5150]

Thanks everyone, call this one solved. The only problem was with my ability to read a meter. (Oh yea, the little m means mili...)
The driver tube must have liked being reseated cause now I'm getting about 215 out of one and the other is still at 190.
 Hooked up and playing on the bench. Just a little scratchiness (not related to any controls) the kind that immediately starts to cook out. Gonna just let it run for a while.
I guess I have to clean up the bench so I can put some clear coat on the base.
Thanks again 

[fullheadofnothing]

Somewhere in the 30s if I remember right. Something that's a star should be 0 as it's on the ground bus.

32 is the terminal in question, and it should be 0Ω.