OT8 for 8 ohm question

ramalamadingdong · 4616

« previous next »
Pages: 1   Go Down

0 Members and 1 Guest are viewing this topic.

Offline ramalamadingdong

  • Newbie
  • *
    • Posts: 9
on: November 12, 2015, 12:20:05 PM
I wired according to the manual, but upon reading the directions further, it looks like the wiring is backwards. I'd have to cross the wires over themselves or reverse the transformer. Anyone else have this issue? Did I wire the trans former backwards and not realize it? Help! I've come so far!


Offline fullheadofnothing

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 1487
  • A noble spirit embiggens the smallest man
Reply #1 on: November 12, 2015, 01:00:08 PM
There was a batch of OT-1s that had backwards lugs. This was a while ago, though, and those transformers got labels specifying the error. Can you provide pictures of what this looks like?

If I knew who you were, I could look up your order and figure out if it was old enough to be possible...

Joshua Harris

I Write the Manuals That Make The Whole World Sing
Kit Packer Emeritus

Offline ramalamadingdong

  • Newbie
  • *
    • Posts: 9
Reply #2 on: November 12, 2015, 02:24:40 PM
july of last year

They had the labels, but they said to follow the wiring directions for the transformer, which I have. Should I just turn them around then?
« Last Edit: November 12, 2015, 02:27:00 PM by ramalamadingdong »


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19750
Reply #3 on: November 12, 2015, 02:58:03 PM
Quote from: ramalamadingdong on November 12, 2015, 02:24:40 PM
july of last year

They had the labels, but they said to follow the wiring directions for the transformer, which I have. Should I just turn them around then?
If the wires are going to the correct numbers that are molded into the bobbins, then you're good to go.  I do not believe that wire length will be much of an issue, I would not turn them around.

-PB

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline ramalamadingdong

  • Newbie
  • *
    • Posts: 9
Reply #4 on: November 13, 2015, 05:06:32 AM
Sounds like I got it right then. I've checked the numbers 2 or three times. I may be going slow, but I'm going carefully!


Offline Doc B.

  • Administrator
  • Hero Member
  • *****
    • Posts: 9657
    • Bottlehead
Reply #5 on: November 13, 2015, 05:57:51 AM
You're doing it right! Enjoy the process.

Dan "Doc B." Schmalle
President For Life
Bottlehead Corp.

Pages: 1   Go Up
« previous next »