Twisted pair cable in reduction

[Yvanyvan]

Hello everyone!

I am currently building reduction, but not from the original kit, so I struggle to find shielded twisted pair required. I'm quite new to diy audio so sorry for the stupid question.

The question is - can I use two-pair shielded twisted pair and remove excessive pair or maybe there are some other quick alternatives?

Ps I do not want to order the cable online as the delivery cost and time are too high.

Thanks in advance!

Ivan

[Tom-s]

When using a quad type cable it's just as easy to solder the ends into pairs and use it that way.

[Doc B.]

I am currently building reduction, but not from the original kit,

I'm not clear on this, but it sounds like you are maybe attempting to build a copy of one of our products. If that is the case, I am sorry to say we cannot offer any tech support.

[Yvanyvan]

I'm not clear on this, but it sounds like you are maybe attempting to build a copy of one of our products. If that is the case, I am sorry to say we cannot offer any tech support.

I've purchased partly finished (almost not started in fact) kit from a friend with some parts missing and original assembly manual from you

[Doc B.]

Ah, OK. In that case, yes, you can use two-pair cable and just connect the matching colors at each end so you end up with the equivalent of two wires in the cable.

[Yvanyvan]

Ah, OK. In that case, yes, you can use two-pair cable and just connect the matching colors at each end so you end up with the equivalent of two wires in the cable.

Thanks for support!