1
Bottlehead DAC / Is the Bottlehead DAC repairable?
« Last post by pdxgrampa on Today at 09:42:31 AM »Mine seems to have given up the ghost.
Is it worth repairing?
Greg
Is it worth repairing?
Greg
Recent Posts
2
General Discussion / sunrise
« Last post by Jay on Today at 09:03:23 AM »I like how the sunlight diffracted through the glass
3
Eros Phono / Re: Loss of R channel post Sowter 1990 SUT
« Last post by Brooklynbottle on Today at 05:03:33 AM »Thanks. I'll double check and post a photo if things don't improve.
That solder job was a bit messy w/ the multi strand Sowter wire.
Appreciate the insight!
That solder job was a bit messy w/ the multi strand Sowter wire.
Appreciate the insight!
4
Eros Phono / Re: Loss of R channel post Sowter 1990 SUT
« Last post by Thermioniclife on Today at 04:08:42 AM »I think I would check for a solder bridge between the center post and the shell of the input connector. Posting pictures can be helpful.
5
Eros Phono / Loss of R channel post Sowter 1990 SUT
« Last post by Brooklynbottle on Yesterday at 05:59:49 PM »Not being one to leave well enough alone, I've managed to loose my R channel post SUT installation. I'm using the Sowter 1990 w/ a Hanah SL cart.
I double checked function w/ the original MM cart (which worked fine prior to my "improvement").
If I crank the volume on my amp, I get the expected hum in both channels.
No signal from the right channel of the phono w/ either cart.
Switched e86's, no dice.
I carefully followed the directions for Sowter installation as posted.
Left channel sounds great.
I'm in uncharted territory here as far as diagnostics go.
Any suggestions would be greatly appreciated!
I double checked function w/ the original MM cart (which worked fine prior to my "improvement").
If I crank the volume on my amp, I get the expected hum in both channels.
No signal from the right channel of the phono w/ either cart.
Switched e86's, no dice.
I carefully followed the directions for Sowter installation as posted.
Left channel sounds great.
I'm in uncharted territory here as far as diagnostics go.
Any suggestions would be greatly appreciated!
6
General Discussion / Pipette and Subette demo June 15th
« Last post by Doc B. on Yesterday at 01:59:55 PM »Mark your calendar for our demo session with the Pipette and Subette speakers on Saturday June 15th at noon at our studio. I'll also have cool stuff for sale as I continue to reduce the accumulation of gear and software in preparation for our move at the end of summer.
7
BeePre / Re: Resistance Check on 52
« Last post by Emoreigns on Yesterday at 07:38:28 AM »Does this tell you anything Paul? These values seem to be correct, and double checking it looks like I've got all the resistors in the right spots. I just cant figure out why my resistance readings are so off...
8
Sublime Subwwofer Amplifier kit / Shielded twisted pair cable
« Last post by benzxc on May 14, 2024, 05:57:06 AM »I was wondering where I can get some more of the shielded twisted pair cable (and the other solid core wires for that matter). I cut some the wrong length and did a poor job of stripping the outer jacket off the shielded one.
9
Eros Phono / Re: Eros 2
« Last post by Doc B. on May 14, 2024, 05:07:54 AM »BeePre2 is about 11.5"Dx17.5"Wx9" H. Allow an inch or two clearance above that for air flow.
10
Crack / Re: Low noise + wrong voltages
« Last post by vermeil on May 13, 2024, 10:22:06 PM »Here are the new voltages:
small board:
0A 71V
0B 206 V
1A 214 V
1B 214 V
small board:
0A 71V
0B 206 V
1A 214 V
1B 214 V