News:
June 04, 2023, 08:04:30 PM

Author Topic: Clarification on the 10k uf cap mounting  (Read 1048 times)

0 Members and 1 Guest are viewing this topic.

Offline ALL212

  • Sr. Member
  • ****
  • Posts: 539
Clarification on the 10k uf cap mounting
« on: January 05, 2018, 11:56:50 AM »
Bottom of page 46 - 6.3 electrolytic into the outboard holes of Y and Y+ on the B side.

The stack of three holes furthest from the mounting hole (bB) is NOT what I use.  The single hole closest to the mounting hole is Y?  The y+ side has no such confusion.  The picture shows using the single hole on the Y.

I'm going with the picture but since it says outboard hole and Y only seems to have 1 hole I'm just checking.

THanks!
Aaron
Aaron Luebke

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 18352
Re: Clarification on the 10k uf cap mounting
« Reply #1 on: January 05, 2018, 12:52:26 PM »
The stack of three holes by bB is simply the connections to bB.

The Y+ and Y- (it's a bit easier to see the "-" on the other side of the board) are their own set of holes, with one set designed to fit a small resistor (33K in this case) and the other a bit heftier to support a capacitor.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline ALL212

  • Sr. Member
  • ****
  • Posts: 539
Re: Clarification on the 10k uf cap mounting
« Reply #2 on: January 05, 2018, 02:06:02 PM »
Thanks PB!  Much Appreciated.

Aaron
Aaron Luebke