Crack-a-two-a

Pages: [1] 2 3 Go Down

	Subject / Started by	Replies / Views	Last post
0 Members and 4 Guests are viewing this board.
	Tube Rolling Started by TurbOSquiD77 « 1 2 3 4 »	51 Replies 7080 Views	May 30, 2019, 04:31:18 AM by L0rdGwyn
	New Build Crack-a-two-a Started by SakoAmp	11 Replies 235 Views	May 29, 2019, 04:24:24 AM by ALL212
	Crack-a-two-a completed! Started by ALL212	10 Replies 1202 Views	February 14, 2019, 07:50:00 PM by itsikhefez
	6F8G grounding Started by L0rdGwyn	5 Replies 174 Views	February 13, 2019, 10:01:19 AM by L0rdGwyn
	A few questions for the Resistance Checks Started by luckme10	3 Replies 314 Views	January 03, 2019, 09:09:20 AM by Paul Birkeland
	Barely high voltage on Low Current C4S Started by cmilleville	1 Replies 463 Views	October 15, 2018, 11:36:28 AM by Doc B.
	Static in Right Channel Started by Jimb0	1 Replies 462 Views	June 12, 2018, 04:17:25 AM by Paul Birkeland
	Hum left channel but goes away after 20 seconds? Started by Jimb0	1 Replies 303 Views	June 10, 2018, 01:07:19 PM by Paul Birkeland
	Troubleshooting Resistance Checks Started by ksolis01 « 1 2 3 »	31 Replies 1553 Views	June 06, 2018, 01:02:56 PM by Paul Birkeland
	Crack-a-two-a Build Log Started by L0rdGwyn « 1 2 3 »	34 Replies 3159 Views	June 05, 2018, 01:38:28 PM by L0rdGwyn
	Right channel hum and no signal Started by Sp33ls « 1 2 3 4 »	57 Replies 1835 Views	May 20, 2018, 02:42:10 PM by Sp33ls
	Balance Knob Question Started by Jimb0	2 Replies 336 Views	May 12, 2018, 12:20:41 PM by Jimb0
	Problems attaching heatsink to High Current C4S Board Started by Jimb0	1 Replies 278 Views	May 11, 2018, 08:14:23 AM by Paul Birkeland
	Transformer Secondary Test 3.5V instead of 3.3V on Terminal 12 and 13 Started by Jimb0	3 Replies 271 Views	May 09, 2018, 11:49:51 AM by Doc B.
	Crack-a-two-a as Preamp? Started by BNAL	3 Replies 651 Views	May 04, 2018, 03:50:22 AM by Paul Birkeland
	First kit? Started by nad88	2 Replies 351 Views	March 26, 2018, 06:05:14 PM by Paul Birkeland
	mW output on Crack-a-two-a? Started by HF9	1 Replies 466 Views	March 12, 2018, 01:08:49 PM by Doc B.
	Balance issue? Pot issue? Started by Sp33ls	13 Replies 622 Views	February 22, 2018, 06:06:37 AM by Paul Birkeland
	Down to the wire and then....EEK! Started by ALL212	4 Replies 455 Views	January 24, 2018, 04:40:26 AM by ALL212
	Clarification on the 10k uf cap mounting Started by ALL212	2 Replies 384 Views	January 05, 2018, 02:06:02 PM by ALL212

Pages: [1] 2 3 Go Up

Normal Topic
Hot Topic (More than 15 replies)
Very Hot Topic (More than 100 replies)

Locked Topic
Sticky Topic
Poll