Clarification on the 10k uf cap mounting

ALL212 · 3237

0 Members and 1 Guest are viewing this topic.

Offline ALL212

  • Sr. Member
  • ****
    • Posts: 542
on: January 05, 2018, 11:56:50 AM
Bottom of page 46 - 6.3 electrolytic into the outboard holes of Y and Y+ on the B side.

The stack of three holes furthest from the mounting hole (bB) is NOT what I use.  The single hole closest to the mounting hole is Y?  The y+ side has no such confusion.  The picture shows using the single hole on the Y.

I'm going with the picture but since it says outboard hole and Y only seems to have 1 hole I'm just checking.

THanks!
Aaron

Aaron Luebke


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19732
Reply #1 on: January 05, 2018, 12:52:26 PM
The stack of three holes by bB is simply the connections to bB.

The Y+ and Y- (it's a bit easier to see the "-" on the other side of the board) are their own set of holes, with one set designed to fit a small resistor (33K in this case) and the other a bit heftier to support a capacitor.


Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man


Offline ALL212

  • Sr. Member
  • ****
    • Posts: 542
Reply #2 on: January 05, 2018, 02:06:02 PM
Thanks PB!  Much Appreciated.

Aaron

Aaron Luebke