Troubleshooting Resistance Checks

ksolis01 · 20978

« previous next »
Pages: 1 2 3   Go Down

0 Members and 1 Guest are viewing this topic.

Offline ksolis01

  • Jr. Member
  • **
    • Posts: 16
Reply #30 on: June 06, 2018, 12:05:49 PM
Quote from: Caucasian Blackplate on June 06, 2018, 11:53:45 AM
The voltage across the 2.49K resistor on the center C4S board above the 12AU7.  It should be well under 5V on both sides.
Did another check. The b side 59V value was actually due to remaining 6AQ5 tube being loose on one side so it is 54V. What should I check since the values are way off 5V?


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19745
Reply #31 on: June 06, 2018, 01:02:56 PM
I would suspect that the ground wire (or jumper) feeding that portion of the board is broken.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Pages: 1 2 3   Go Up
« previous next »