BeePre2 - filament voltage power supply [resolved]

Yossihaimberg · 2176

« previous next »
Pages: 1 2   Go Down

0 Members and 2 Guests are viewing this topic.

Offline Yossihaimberg

  • Jr. Member
  • **
    • Posts: 22
Reply #15 on: February 23, 2025, 03:02:09 PM
No continuity...


Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 20118
Reply #16 on: February 23, 2025, 03:08:05 PM
You can blob some solder up top to connect them together.  The solder pad for the 237 ohm resistor looks like it's totally gone.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Yossihaimberg

  • Jr. Member
  • **
    • Posts: 22
Reply #17 on: February 23, 2025, 03:19:48 PM
No continuity...


Offline Yossihaimberg

  • Jr. Member
  • **
    • Posts: 22
Reply #18 on: February 23, 2025, 03:20:59 PM
Please disregard my last posting


Offline Yossihaimberg

  • Jr. Member
  • **
    • Posts: 22
Reply #19 on: February 23, 2025, 03:40:10 PM
OK, now there is continuity, but my multi-meter just died on me >:(. I'll get a new one and measure again.

Thanks for being so patience with me.


Offline Yossihaimberg

  • Jr. Member
  • **
    • Posts: 22
Reply #20 on: February 24, 2025, 07:43:35 AM
OK, all works as it should be. Thank you for accurately diagnosing the problem with the continuity between the 2 resistors!!!


Pages: 1 2   Go Up
« previous next »