News:
December 01, 2023, 01:23:50 AM
« previous next »
Pages: [1]   Go Down

Author Topic: 7 pin socket question  (Read 1036 times)

0 Members and 1 Guest are viewing this topic.

Offline Markkr

  • Full Member
  • ***
  • Posts: 70
7 pin socket question
« on: January 22, 2021, 02:01:26 PM »
Is it expected to have to drill the top plate holes to fit the 7 pin sockets? They do not fit inside the existing holes.
Logged

Offline Markkr

  • Full Member
  • ***
  • Posts: 70
Re: 7 pin socket question
« Reply #1 on: January 22, 2021, 02:22:35 PM »
Disregard, found same post on page 2 :-)
Logged

Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 18925
Re: 7 pin socket question
« Reply #2 on: January 22, 2021, 02:40:00 PM »
The sockets we have been getting grew on us a little bit, and some panels went out without enlarged 7 pin holes.  A round file will nudge the hole size up a little bit to get the socket in.
Logged
Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man

Offline Markkr

  • Full Member
  • ***
  • Posts: 70
Re: 7 pin socket question
« Reply #3 on: January 22, 2021, 03:36:53 PM »
Quote from: Paul Birkeland on January 22, 2021, 02:40:00 PM
The sockets we have been getting grew on us a little bit, and some panels went out without enlarged 7 pin holes.  A round file will nudge the hole size up a little bit to get the socket in.

Thanks thats exactly what I used, all good now.
Logged
Pages: [1]   Go Up
« previous next »