7 pin socket question

Markkr · 1286

0 Members and 1 Guest are viewing this topic.

Offline Markkr

  • Full Member
  • ***
    • Posts: 70
on: January 22, 2021, 02:01:26 PM
Is it expected to have to drill the top plate holes to fit the 7 pin sockets? They do not fit inside the existing holes.



Offline Markkr

  • Full Member
  • ***
    • Posts: 70
Reply #1 on: January 22, 2021, 02:22:35 PM
Disregard, found same post on page 2 :-)



Offline Paul Birkeland

  • Global Moderator
  • Hero Member
  • *****
    • Posts: 19316
Reply #2 on: January 22, 2021, 02:40:00 PM
The sockets we have been getting grew on us a little bit, and some panels went out without enlarged 7 pin holes.  A round file will nudge the hole size up a little bit to get the socket in.

Paul "PB" Birkeland

Bottlehead Grunt & The Repro Man


Offline Markkr

  • Full Member
  • ***
    • Posts: 70
Reply #3 on: January 22, 2021, 03:36:53 PM
The sockets we have been getting grew on us a little bit, and some panels went out without enlarged 7 pin holes.  A round file will nudge the hole size up a little bit to get the socket in.

Thanks thats exactly what I used, all good now.